Supra P500 Pro KeySafe™ Installation Help

For instructions on how to install your Supra P500 Pro KeySafe™ please follow the easy step by step guide below.

Mounting the Supra P500 Pro KeySafe™

1. Use the mounting template to position the holes so they are as close to the centre of the brick as possible. Do not install screws into mortar since this will weaken the mounting. 

2. Use the mounting template to drill 4 mounting holes using a 3/16” or 5mm masonry drill bit to a depth of at least ¼” or 7mm deeper than the length of the screw. Clean out dust and debris from all holes. 

3. Position the KeySafe on the 4 holes and drive the screws directly into the brick. Note: You must use the size 6x60mm masonry screws included with models 002045 and 002046 to maintain LPS 1175 security certification. When mounting on a rendered wall, the maximum thickness of the render cannot exceed 10mm. 

Note: a rendered or wood substrate is not covered within the approval to LPS 1175. 

Note: Do not mount KeySafe closer than 6” or 15cm to the corner of a masonry surface. Make sure key safe is mounted flush with masonry surface and the masonry screws are only installed directly into brick. Never install masonry screws into mortar. Minimize all gaps between back of key safe and masonry surface. 

4. Tighten the screws until the heads are snug against the back of the key safe. Be careful not to over tighten the screws. 

DO NOT USE A DRILL.

Please refer to the P500 Pro KeySafe™ user guide below if you have purchased the P500 Pro KeySafe™ - to fit Grade 2 Alarm System version.

If you have other installation related questions, visit our General Installation FAQs section.

If you have any questions you can contact our friendly UK-based team, Monday to Thursday 9am to 5.30pm and Friday 9am to 5pm, on 0330 363 0303, email us at hello@keysafe.co.uk or using the live chat facility at www.keysafe.co.uk