Supra P500 Pro KeySafe™ Code Setting Help

For instructions on how to code your Supra P500 Pro KeySafe™ please follow our easy step by step guide below.

A. Setting your combination 

There is no pre-set combination on your Supra P500 Pro KeySafe™. Select your own combination. Each number/letter can only be used once. 

Do not use a combination that can be easily guessed.
 

1. Hold the clear plastic tab and pull open the weather cover. 

2. Press down on the CLEAR button. 

3. Turn the OPEN handle clockwise 180° to open the lid. 

4. Use a screwdriver to remove the screw from the code tamper plate. 

5. Slide the tamper plate towards the hinge of the keysafe, pull out the plate and remove the plastic card from the key cover.

6. There are 10 numbered buttons and 2 lettered buttons with arrows on the back of the lid. Arrows pointing away from the hinge are OFF and are not part of the combination. Arrows pointing towards the hinge are ON and are part of the combination. 

7. With the keysafe open, turn the open handle counter-clockwise 180°, back to the locked position. Important! The OPEN handle must be in LOCKED position before the code can be changed. Forcing the setting buttons when in the OPEN position may damage the keysafe and void the warranty. 

8. Use the code change tool on the plastic card to set the combination.  Note: Do not use a screwdriver! To add a number or letter to the code, use the code change tool to push in the grooved arrow by the number/letter you wish to set. Turn 180° until the arrow pops back up completely and the arrow points in the ON direction. To remove a number or letter from the code, use the code change tool to push in the grooved arrow by the number/letter you wish to set. Turn 180° until the arrow pops back up completely and the arrow points in the OFF direction. 

9. Replace the plastic card on the key cover. Place the code tamper plate over the back of the lid and slide into place. Secure the plate with the screw. 

Optional: To make the combination tamper-resistant, secure the plate with the anti-tamper screw located in the fitting kit provided using a Torx T15 anti-tamper driver. 

B. Testing your combination 

1. Make sure OPEN handle is in the locked position. If not, turn OPEN handle counter-clockwise until it’s in the locked position. On the front of the keysafe, press only the buttons in your combination. Press each button in until it clicks. If you press the wrong button, push down on the clear button and enter your code again. 

2. Turn the OPEN handle clockwise 180° to open. If the combination is set correctly, the OPEN handle will turn fully and the locking bolt will retract. If not, push down the CLEAR button and refer to section A, Setting your combination. 

If you have other code setting questions, visit our General Code Setting FAQs section.

If you have any questions you can contact our friendly UK-based team, Monday to Thursday 9am to 5.30pm and Friday 9am to 5pm, on 0330 363 0303, email us at hello@keysafe.co.uk or using the live chat facility at www.keysafe.co.uk