Supra S5 Permanent KeySafe™ Code Setting Help

Setting your code for your Supra S5 Permanent key safe is really easy. Here's how:

Before you begin, please remember:

There is no pre-set combination code in your KeySafe

You will need to select your own combination, ideally featuring between 5 and 7 digits

Each number can only be used once

Do not use a combination that can be easily guessed

There is no override or reset code. Make a note of your code and store it somewhere safe.

Setting your combination

Pull open the black weather cover.

Press down on the CLEAR button (located in the centre of the KeySafe) and then release.

Press down on the OPEN button and remove the lid (the part with the black buttons).

Slide the white plastic instruction card on the back of the lid out and remove. This will reveal ten grey buttons on the back of the lid. Each of these grey buttons corresponds to the black buttons on the front of the KeySafe. These buttons each have small arrows. 

Arrows pointing towards the locking pin are OFF and are not part of the combination. Arrows pointing away from the locking pin are ON and are part of the combination.

Use the white plastic card (code change tool) provided to set your combination.

Note: Do not use a screwdriver!

To add a number to your code, use the code change tool to push in the grooved button by the number you wish to set. Turn 180° until the button pops back up completely and the arrow points in the ON direction (away from the hinge). To remove a number or letter from the code, use the code change tool to push in the grooved button by the number you wish to unset. Turn 180° until the button pops back up completely and the arrow points in the OFF direction (towards the locking pin).

Return the white plastic card over the back of the lid.

Testing your combination

1. On the front of the KeySafe, pressing only the buttons in your combination, press each button in until it clicks. If you press the wrong button, push down on the clear button and enter your code again.
2. Press down on the OPEN button open. If the combination is set correctly, the locking pin will retract fully. If it does not, push down the CLEAR button and check to ensure you have entered the correct code. Refer to "Setting your combination" if you continue to experience difficulty.

You must enter your code to both open and close your KeySafe.

Opening and closing your KeySafe

1. Once you have tested your code you will need to enter it again to close the KeySafe. Once you enter your code, you do not have to press the OPEN button until you are ready. There is no time limit between entering your code and operating the OPEN button.
2. Offer the bottom of the lid into the bottom of the vault, pull down on the OPEN button and push the lid closed. Once in place release the OPEN button. Check your KeySafe is now locked shut by sliding down the OPEN button. If correctly locked, you should not be able to open the Keysafe without re-entering your code.

Ensure you keep a copy of your code safe and only disclose your code to those that need to know. There is no override or reset code. If you have a lifeline or pull-cord care package, be sure to inform the monitoring centre where your key safe is located and ensure they always have a record of your most recent code in case of an emergency.

If you have any questions you can contact our friendly UK-based team, Monday to Thursday 9am to 5.30pm and Friday 9am to 5pm, on 0330 363 0303, email us at hello@keysafe.co.uk or using the live chat facility at www.keysafe.co.uk